Now if you pause at a moderate "Z" height, loading a filament isn't a problem, however if you want to have a pause at a low height (say a few millimeters) than getting filament to load may be an issue because the purge hits the bed immediately due to the close proximity of the nozzle.Įnter "Additional terminal commands for post processing" stage right. This script also address another issue not currently addressed by raise3D which is: their pause routine will keep the bed at the same height. But, since S3D is awesome I wanted to figure out how to do it. If you have this printer you know that there is no firmware support for pausing at a specific height and raise3D recommends you use the feature in ideamaker to pause at a specific height. Specifically how to add a pause at a specific layer while using a Raise3D printer. Rarely do I get to contribute much however I think I have figured out how to do something that hasn't been posted yet, so I wanted to share.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |